Lập trình ngắt timer0 pic8f452
em viết đoạn chương trình này nhưng không chạy là sao hả các bác
#include <18f452.h>
#device adc=8
#FUSES NOWDT //No Watch Dog Timer
#FUSES WDT128 //Watch Dog Timer uses 1:128 Postscale
#FUSES RC_IO //Resistor/Capacitor Osc
#FUSES NOPROTECT //Code not protected from reading
#FUSES NOOSCSEN //Oscillator switching is disabled, main oscillator is source
#FUSES BROWNOUT //Reset when brownout detected
#FUSES NOPUT //No Power Up Timer
#FUSES STVREN //Stack full/underflow will cause reset
#use delay(clock=20000000)
#use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bi ts=8)
int16 count;
int8 led ;
#int_timer0
void ngat_timer0()
{
set_timer0(57);
++count;
if(count>=98)
{
count=0;
led<<=1;
led+=1;
}
}
void main()
{
setup_adc_ports(NO_ANALOGS);
setup_adc(ADC_OFF);
setup_psp(PSP_DISABLED);
setup_spi(SPI_SS_DISABLED);
setup_wdt(WDT_OFF);
setup_timer_0(RTCC_INTERNAL|RTCC_DIV_256);
setup_timer_1(T1_DISABLED);
setup_timer_2(T2_DISABLED,0,1);
set_tris_b(0);
set_timer0(57);
enable_interrupts(global);
enable_interrupts(int_timer0);
while(1)
{
output_b(led);
}
}
#include <18f452.h>
#device adc=8
#FUSES NOWDT //No Watch Dog Timer
#FUSES WDT128 //Watch Dog Timer uses 1:128 Postscale
#FUSES RC_IO //Resistor/Capacitor Osc
#FUSES NOPROTECT //Code not protected from reading
#FUSES NOOSCSEN //Oscillator switching is disabled, main oscillator is source
#FUSES BROWNOUT //Reset when brownout detected
#FUSES NOPUT //No Power Up Timer
#FUSES STVREN //Stack full/underflow will cause reset
#use delay(clock=20000000)
#use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bi ts=8)
int16 count;
int8 led ;
#int_timer0
void ngat_timer0()
{
set_timer0(57);
++count;
if(count>=98)
{
count=0;
led<<=1;
led+=1;
}
}
void main()
{
setup_adc_ports(NO_ANALOGS);
setup_adc(ADC_OFF);
setup_psp(PSP_DISABLED);
setup_spi(SPI_SS_DISABLED);
setup_wdt(WDT_OFF);
setup_timer_0(RTCC_INTERNAL|RTCC_DIV_256);
setup_timer_1(T1_DISABLED);
setup_timer_2(T2_DISABLED,0,1);
set_tris_b(0);
set_timer0(57);
enable_interrupts(global);
enable_interrupts(int_timer0);
while(1)
{
output_b(led);
}
}
Comment