Chào các bạn và Hà.
Mình mới viết được chương trình giao tiếp I2C đơn giản dùng các hàm của CCS.
Mời các bạn xem và cho nhận xét
Master: truyền dữ liệu cho Slave. Mỗi lần truyền 1 byte.
Code:
#include <16F877A.H>
#fuses XT,NOWDT,NOPROTECT,NOLVP
#use Delay(Clock=4000000)
#define SLAVE_ADDRESS 0x10
#use i2c(master, sda=PIN_C4, scl=PIN_C3)
void write_I2C(int8 a)
{
i2c_start();
i2c_write(SLAVE_ADDRESS);
i2c_write(a);
i2c_stop();
}
void main()
{
int8 value;
value = 0;
while(1){
write_I2C(value);
value++;
delay_ms(100);
}
}
Slave thì chỉ tiến hành kiểm tra có phải Master truyền hay kô. Nếu truyền thì nhận byte dữ liệu và hiển thị lên port_B:
Code:
#include <16F877A.H>
#fuses XT,NOWDT,NOPROTECT,NOLVP
#use delay(Clock=4000000)
#use i2c(SLAVE, SDA=PIN_C4, SCL=PIN_C3, address=0x10)
int8 value;
#INT_SSP
void i2c_isr()
{
int8 state;
int8 address;
state = i2c_isr_state();
if(state == 0)
address = i2c_read();
else if(state < 0x80)
value = i2c_read();
}
void main()
{
enable_interrupts(GLOBAL);
enable_interrupts(INT_SSP);
set_tris_b(0x00);
while(1){
output_b(value);
}
}
Thân
hoanf