PIC Vietnam

Go Back   PIC Vietnam > Robotics > Matlab-Simulink & Labview & 20-Sim

Tài trợ cho PIC Vietnam
Trang chủ Đăng Kí Hỏi/Ðáp Thành Viên Lịch Tìm Kiếm Bài Trong Ngày Ðánh Dấu Ðã Ðọc Vi điều khiển

Matlab-Simulink & Labview & 20-Sim Các công cụ mô phỏng đa ngành...

 
 
Ðiều Chỉnh Xếp Bài
Prev Previous Post   Next Post Next
Old 07-01-2010, 03:27 PM   #1
qiang412
Nhập môn đệ tử
 
Tham gia ngày: Dec 2008
Bài gửi: 4
:
Help Me! về simulink và Fuzzy

Mình đang làm về điều khiển mờ, tuy nhiên khi mô phỏng trên simulink thì sảy ra lỗi, không thể tiếp tục được
thông báo lỗi như sau:
"Error in 'temp/Fuzzy Logic Controller': Parameter 'temp' cannot be evaluated. MATLAB error message: Error, 'temp' is currently in use by a simulation and can not be accessed programmatically"

sau khi thực hiện Export file fuzzy sang Workspace thì lại báo lỗi sau:
error 1:
"MinMax does not accept 'boolean' signals. The input and output signal(s) of 'temp/Fuzzy Logic Controller/FIS Wizard/Defuzzification1/Max (COA)' must be one of the MATLAB 'uint8', 'uint16', 'uint32', 'int8', 'int16', 'int32', 'single', or 'double' data types, or one of the Fixed-point data types"

error 2:
"An error occurred while propagating data type 'boolean' from 'temp/Fuzzy Logic Controller/FIS Wizard/Defuzzification1/Zero Strength (COA)', output port 1'
em làm một ứng dụng nhỏ để thừ nhưng không được, file như sau:
http://www.mediafire.com/?zzgeddhhtuj
bác nào đã làm về phần này giúp em với, thanks nhiều
qiang412 vẫn chưa có mặt trong diễn đàn   Trả Lời Với Trích Dẫn
 

Ðiều Chỉnh
Xếp Bài

Quyền Sử Dụng Ở Diễn Ðàn
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is Mở
Smilies đang Mở
[IMG] đang Mở
HTML đang Tắt

Chuyển đến


Múi giờ GMT. Hiện tại là 09:17 PM.


Được sáng lập bởi Đoàn Hiệp
Powered by vBulletin®
Page copy protected against web site content infringement by Copyscape
Copyright © PIC Vietnam