|
Tài trợ cho PIC Vietnam |
dsPIC - Bộ điều khiển tín hiệu số 16-bit Theo dự kiến của Microchip, vào khoảng năm 2011 dsPIC sẽ có doanh số lớn hơn PIC |
|
Ðiều Chỉnh | Xếp Bài |
19-10-2008, 01:31 AM | #5 |
Nhập môn đệ tử
Tham gia ngày: Jul 2008
Bài gửi: 7
: |
Anh Nam ơi giúp em với , em đang lập trình cho dsPIC30F2010 bằng MPLAB C30 . Em lập trình không có lỗi tạo ra được file .hex rồi , Nhưng khi nạp bằng PICkit2 thì nó cứ báo lỗi "Warning : some configuration words not in hex file .Ensure default values above right are acceptable " . anh giúp em với em chịu không thể tìm ra được tại sao .
đây là code em viết : /***** This is a dsPIC30F2010. */ #include <p30f2010.h> // #include <p30f4012.h> #include <limits.h> #include <dsp.h> /***** Set the configuration fuses. */ /* Use crystal oscillator, using a phased-lock loop to multiply the clock speed by 16 */ _FOSC(CSW_FSCM_OFF & XT_PLL16); /* Disable the watchdog timer */ _FWDT(WDT_OFF); /* Set brownout limit to 2.0 volts, startup timer to 64 ms, enable the reset pin */ _FBORPOR(PBOR_ON & BORV_20 & PWRT_64 & MCLR_EN); /* No code protection needed */ _FGS(CODE_PROT_OFF); /* Use an MPLAB ICD 2 as the debugger, use the programming lines as the debug ports */ _FICD( ICS_NONE); int main(void) { int i; for(i=0;i<=1000;i++); return 1; } |
|
|