PIC Vietnam

Go Back   PIC Vietnam > Microchip PIC > Bootloaders - Programmers - Debuggers - Emulators

Tài trợ cho PIC Vietnam
Trang chủ Đăng Kí Hỏi/Ðáp Thành Viên Lịch Bài Trong Ngày Vi điều khiển

Bootloaders - Programmers - Debuggers - Emulators Những công cụ cần thiết để lập trình cho PIC/dsPIC

 
 
Ðiều Chỉnh Xếp Bài
Prev Previous Post   Next Post Next
Old 13-05-2008, 01:02 PM   #3
anh_gioi
Đệ tử 6 túi
 
Tham gia ngày: Oct 2006
Bài gửi: 147
:
hic.. em viết 1 câu lệnh rất don giản cho con PIC 18F4431 nhu vầy mà nó không chạy.các anh chỉ bảo dùm em cái.
Trích:

#include "C:\Documents and Settings\anh gioi\Desktop\pic\pic02\pic02.h"


void main()
{

setup_adc_ports(NO_ANALOGS|VSS_VDD);
setup_adc(ADC_OFF|ADC_TAD_MUL_0|ADC_WHEN_INT0|ADC_ INT_EVERY_OTHER);
setup_spi(FALSE);
setup_wdt(WDT_OFF);
setup_timer_0(RTCC_INTERNAL);
setup_timer_1(T1_DISABLED);
setup_timer_2(T2_DISABLED,0,1);
setup_oscillator(False);

// TODO: USER CODE!!
while(1)
{
output_b(0x00);
delay_ms(1000);
output_b(0xff);
delay_ms(1000);
}
}
trong file .h
Trích:
#include <18F4431.h>
#device adc=8

#FUSES NOWDT //No Watch Dog Timer
#FUSES WDT128 //Watch Dog Timer uses 1:128 Postscale
#FUSES HS //High speed Osc (> 4mhz)
#FUSES NOPROTECT //Code not protected from reading
#FUSES IESO //Internal External Switch Over mode enabled
#FUSES BROWNOUT //Reset when brownout detected
#FUSES BORV27 //Brownout reset at 2.7V
#FUSES NOPUT //No Power Up Timer
#FUSES NOCPD //No EE protection
#FUSES STVREN //Stack full/underflow will cause reset
#FUSES NODEBUG //No Debug mode for ICD
#FUSES LVP //Low Voltage Programming on B3(PIC16) or B5(PIC18)
#FUSES NOWRT //Program memory not write protected
#FUSES NOWRTD //Data EEPROM not write protected
#FUSES FCMEN //Fail-safe clock monitor enabled
#FUSES NOWINEN //WDT Timer Window Disabled
#FUSES T1LOWPOWER //Timer1 low power operation when in sleep
#FUSES HPOL_HIGH //High-Side Transistors Polarity is Active-High (PWM 1,3,5 and 7)
#FUSES NOWRTC //configuration not registers write protected
#FUSES NOWRTB //Boot block not write protected
#FUSES NOEBTR //Memory not protected from table reads
#FUSES NOEBTRB //Boot block not protected from table reads
#FUSES NOCPB //No Boot Block code protection
#FUSES LPOL_HIGH //Low-Side Transistors Polarity is Active-High (PWM 0,2,4 and 6)
#FUSES PWMPIN //PWM outputs disabled upon Reset
#FUSES MCLR //Master Clear pin enabled
#FUSES FLTAC1 //FLTA input is multiplexed with RC1
#FUSES SSP_RC //SCK/SCL=RC5, SDA/SDI=RC4, SDO=RC7
//#FUSES ER_IO //External resistor osc

#use delay(clock=8000000)
#use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bi ts=8)

cái code này mà sai chắc em học Pic lại từ đầu quá...
anh_gioi vẫn chưa có mặt trong diễn đàn   Trả Lời Với Trích Dẫn
 


Quyền Sử Dụng Ở Diễn Ðàn
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is Mở
Smilies đang Mở
[IMG] đang Mở
HTML đang Tắt

Chuyển đến


Múi giờ GMT. Hiện tại là 10:52 PM.


Được sáng lập bởi Đoàn Hiệp
Powered by vBulletin®
Page copy protected against web site content infringement by Copyscape
Copyright © PIC Vietnam